TECHNYL® A 218S V43 BK 110
43% Glass Fiber Reinforced PA66 · High Rigidity Structural Material
Heat Stabilized
High Flowability
Asia Only
TECHNYL® A 218S V43 BK 110 (previously DOMAMID 66G43H2 110 BK99) is a 43% glass fiber reinforced polyamide 66 (PA66) grade with heat stabilization, specifically developed for injection molding. This product offers an excellent combination of thermal and mechanical properties, delivering exceptional rigidity and strength. Available exclusively for the Asian market, it is an ideal material choice for automotive components, power tools, and garden equipment structural parts.
📋 Product Overview
- Polymer Type: PA66 (Polyamide 66)
- Reinforcement: 43% Glass Fiber
- Heat Stabilized: Yes
- Processing: Injection Molding
- Color: Black
- Availability: Asia Only
- Certifications: RoHS, REACH
- Typical Applications: Automotive Components, Power Tools, Garden Equipment
📊 Technical Data Sheet
Physical Properties
Mechanical Properties (DAM)
Thermal Properties
Electrical Properties
Flammability
✅ FMVSS 302 compliant for automotive interior applications
⚙️ Processing Conditions
80°C
0.2%
260 – 280°C
270 – 300°C
280 – 310°C
60 – 90°C
⚠️ Injection Advice
The material is supplied in airtight bags, ready for use. If the virgin material has absorbed moisture, it must be dried with dehumidified air drying equipment (dew point minimum -20°C). Recommended drying time: 2-4 hours.
High glass fiber content materials cause some wear to processing equipment. Use abrasion-resistant screw and barrel components.
🎯 Target Applications
Engine周边 parts, structural components
Housings, gearboxes, structural brackets
Lawn mower components, structural housings
High-rigidity structural parts
📌 Note: This grade is available exclusively for the Asian market (including China, Japan, Korea, Southeast Asia, etc.). For other regions, please contact DOMO Chemicals for equivalent alternatives.
🌟 Key Advantages
- ✅ Ultra-High Rigidity: 43% glass fiber reinforcement, tensile modulus up to 14800 MPa, flexural modulus 12000 MPa
- ✅ Ultra-High Strength: Tensile strength 200 MPa, flexural strength 300 MPa
- ✅ Excellent Impact Resistance: Charpy notched impact strength 16 kJ/m²
- ✅ High Flowability: Suitable for high-fill molding of complex structural parts
- ✅ Good Surface Quality: Improved surface finish
- ✅ Heat Stabilized: Long-term thermal aging resistance for engine周边 applications
- ✅ FMVSS Compliant: Meets automotive interior flammability standards
- ✅ RoHS & REACH Compliant: Meets global environmental regulations
📌 Material Selection Guide
Disclaimer: The information provided in this documentation corresponds to our technical knowledge at the date of its publication and does not constitute a specification. DOMO cannot anticipate all conditions under which this information and our products may be used. Users are advised to make their own tests to determine the safety and suitability for their own purposes. Unless otherwise agreed in writing, DOMO sells the product without warranties. Unless specifically indicated, this grade is not suitable for pharmaceutical/medical applications.
Source: DOMO Chemicals Official Technical Data Sheet (TECHNYL A 218S V43 BK 110, Document 002109)
Last Updated: May 2023